Compare locomotives
Add a locomotive
Pennsylvania class E3
The E3 was an Atlantic that was built by the PRR parallel to its E2 that was largely similar, but had larger cylinders. Between 1901 and 1910, a total of eight E3, 114 E3a and 56 E3d were built in the Juniata shops at...
| Pennsylvania class E3Remove | |
|---|---|
| Variant | E3a |
| Built | 1903-1905 |
| Manufacturers | Altoona |
| Wheel arrangement | 2B1 |
| Gauge | 1435 mm |
| Length | |
| Service mass | 86183 kg |
| Top speed | |
| Power | |
| Engine |
General
| Property | Pennsylvania class E3E3a |
|---|---|
| Built | 1903-1905 |
| Manufacturers | Altoona |
| Wheel arrangement | 4-4-2 (Atlantic) |
| Gauge | 1,435 mm |
Dimensions and weights
| Property | Pennsylvania class E3E3a |
|---|---|
| Wheelbase | 9.39 m |
| Total wheelbase | 18.35 m |
| Service mass | 86.2 t |
| Adhesion mass | 53.7 t |
| Total mass | 147.4 t |
| Rigid wheelbase | 2.26 m |
| Axle load | 28 t |
| Water capacity | 21,955 l |
| Fuel capacity | 11.8 t (coal) |
Boiler
| Property | Pennsylvania class E3E3a |
|---|---|
| Grate area | 5.156 m² |
| Firebox surface | 15.394 m² |
| Tube heating surface | 229.777 m² |
| Evaporative heating surface | 245.171 m² |
| Total heating surface | 245.2 m² |
Power plant
| Property | Pennsylvania class E3E3a |
|---|---|
| Driver diameter | 2,032 mm |
| Boiler pressure | 14.1 bar |
| Expansion type | simple expansion |
| Cylinders | two, 559 x 660 mm |
Power
| Property | Pennsylvania class E3E3a |
|---|---|
| Power source | steam |
| Estimated power | 1,193 kW (1,622 PS) |
| Starting effort | 121.9 kN |
Calculated values
| Property | Pennsylvania class E3E3a |
|---|---|
| Factor of adhesion | 1 : 4.32 |
| Optimal speed | 60 km/h |
| Power-to-weight ratio | 13.8 kW/t |
| Heating Surface Equivalent | 322.1 m² |
| Cylinder volume/HSE | 1 : 1,005.53 |
| Adhesive weight/Total | 1 : 1.60 |
| Tractive force/Heating surface | 1 : 10.39 |
| Grate area/Heating surface | 1 : 47.55 |
| Firebox/Tube surface | 1 : 14.93 |
