Banner
Navigation
loco-info.com
The reference for locomotives and railcars

New Zealand Railways class DF

New Zealand 1954 10 produced
In the English Electric factory halls

The DF was the first class of diesel locomotives that the NZR procured for use on main lines. The engine used was the well-known turbocharged diesel from English Electric with twelve cylinders and an output of 1,500 hp. In order to be able to maintain an axle load of twelve long tons, the weight had to be distributed over ten axles. Thus there were a total of six powered axles in two bogies and one two-axle bogie at each end.

Originally 31 were ordered, but the order was subsequently reduced to ten. Instead of the remaining 21 DF, 42 smaller DG were ordered, which compared to the DF had half the power and only one cab. The ten locomotives were only used on the North Island and mostly in front of freight trains. They were mainly to be found on lines for which the slightly less powerful class DA had too high an axle load. In 1964 they were renumbered from 1500 to 1509 to the new number range between 1300 and 1309. In the Seventies a transfer to the South Island was planned, but this did not take place due to the lighter class DJ.

Thus, all locomotives were retired between 1972 and 1975. A few years later, the class DF was assigned to a new locomotive from General Motors Diesel. Today only 1301 is preserved, which now carries the old number 1501 again. It was stored outdoors for a long time and was soon in a corresponding state. In 2008 it was taken over by the Diesel Traction Group and is being restored since 2018.

Technical data

General

Built
1954
Manufacturers
English Electric
Wheel arrangement
2-C+C-2
Gauge
1,067 mm (Cape gauge)

Dimensions and weights

Length
17.68 m
Wheelbase
15.85 m
Service mass
106.7 t
Adhesion mass
70.1 t
Rigid wheelbase
3.66 m
Axle load
11.7 t

Power plant

Engine
English Electric 12SVT Mk 2
Engine type
V12 diesel

Power

Power source
diesel-electric
Indicated power
1,119 kW (1,521 PS)
Top speed
97 km/h
Starting effort
171.3 kN

Calculated values

Factor of adhesion
1 : 4.02
Power-to-weight ratio
10.5 kW/t
Adhesive weight/Total
1 : 1.52
Auf Deutsch umschalten

Settings

Your settings are retained for this browser session only.

Consent to cookies

We use cookies to save your display settings. If you decline, the settings are retained only for the current browser session.