Cape Government Railways class 1 4-4-0
South African class 01 4-4-0
A problem with the Cape Government Railways mainline locomotives of the 1870s was the small driver diameter of less than 40 inches. On passenger trains in particular, this led to high wear if they were ran at higher speeds for a longer period of time. In addition, the range of the tank locomotives mostly used was too small for newly opened lines in sparsely populated areas.
The solution was a tender locomotive with a 4-4-0 wheel arrangement and a wheel diameter of 48 inches. First, in 1879, the Avonside Engine Company delivered two locomotives each for the western and eastern networks, which received the numbers W25, W26, E8 and E9. The following year Neilson & Co. added six more for the west and five more for the east, bringing the total to 15.
With the help of these locomotives, the Karoo semi-desert could now also be opened up with fast passenger trains. An average speed of 34 mph was reached on the 339 miles long route from Cape Town to Beaufort West, which was a record for South Africa. When the South African Railways were founded in 1910, the locomotives, which were now classified as class 1, were classified as obsolete. So they became class 01 and got a zero prefixed to their running number. The nine locomotives still in existence at that time were all retired until 1915.
Technical data
General
- Built
- 1879-1880
- Manufacturers
- Avonside, Neilson & Co.
- Wheel arrangement
- 4-4-0 (American)
- Gauge
- 1,067 mm (Cape gauge)
Dimensions and weights
- Length
- 12.60 m
- Wheelbase
- 5.28 m
- Total wheelbase
- 10.16 m
- Service mass
- 23.5 t
- Adhesion mass
- 16.3 t
- Total mass
- 40.8 t
- Rigid wheelbase
- 1.98 m
- Axle load
- 8.2 t
- Water capacity
- 7,730 l
- Fuel capacity
- 2.5 t (coal)
Boiler
- Grate area
- 0.929 m²
- Firebox surface
- 4.831 m²
- Tube heating surface
- 47.659 m²
- Evaporative heating surface
- 52.49 m²
- Total heating surface
- 52.5 m²
Power plant
- Driver diameter
- 1,219 mm
- Boiler pressure
- 9 bar
- Expansion type
- simple expansion
- Cylinders
- two, 356 x 457 mm
Power
- Power source
- steam
- Estimated power
- 149 kW (203 PS)
- Starting effort
- 36.1 kN
Calculated values
- Factor of adhesion
- 1 : 4.42
- Optimal speed
- 26 km/h
- Power-to-weight ratio
- 6.3 kW/t
- Heating Surface Equivalent
- 76.6 m²
- Cylinder volume/HSE
- 1 : 1,184.86
- Adhesive weight/Total
- 1 : 1.45
- Tractive force/Heating surface
- 1 : 14.38
- Grate area/Heating surface
- 1 : 56.50
- Firebox/Tube surface
- 1 : 9.87